BGAFC Vendégkönyv

Σ: 1 post

TCH (statz)

#1, Főfasz (10466)

1479 | #5009 | ^ | Idézet | Wed, 20 May 2020 15:52:46 +02

84.236.*.*

*.pool.digikabel.hu

@Carlos:
This would include G5 and POWER8/9.

The article you linked in stated that only OpenPOWER firmware machines will be supported, so the Macs've been are ruled out.

@Carlos:
The Haiku PowerPC port is not an easy task. For this we have to wait a little longer. I will install it as soon as it's available. Because I saw showcase about BeOS at the time and I was really impressed.
https://twitter.com/mpc7500v2/status/1192484662632964096?s=20

Full BeOS compatibility would be nice, but i think, Haiku is very far from BeOS 5's level yet.

@Carlos:
Finnix got an update these days to 120, but sadly no more PowerPC support.
https://www.finnix.org

I dunno, if version 111 is still supported.

This was expected to be happen for three years. But since they have became systemd-infected, i say we would lose Finnix anyway. Support was always ambiguous when we were talking about Finnix; it's a live sysadmin distro, not an installable and updatable one, so actually there is no conventional support for it. You wrote out the image to a CD or USB pendrive and until you are able to use it, you can use it. I think i'll set all Fienix releases to partial support.

@Carlos:
Ah and VxWorks has no POWER8/9 support. I asked them via mail.

Well, that's too bad.

Kecskebaszók ide!